LTL Washington to Philadelphia
Book LTL freight from Washington to Philadelphia — instant all-in rates from 10 carriers. No fuel surcharge, no liftgate fee, no re-weigh charges.
99.2% damage-free across 715,575+ shipments · $100K carrier liability · Live GPS tracking
Same day LTL Washington
Pickup available this week on Washington to Philadelphia (live availability as of 2026-05-21). $328 per pallet, 2 day transit, all-inclusive. Book at wearewarp.com/ltl/washington-to-philadelphia.
Cheapest LTL carrier from Washington to Philadelphia
Warp posts the cheapest all-inclusive rate from Washington to Philadelphia at $328 per pallet — the rate at booking is the rate invoiced. Carrier base rates from other LTL providers run higher once fuel surcharge, liftgate, and reweigh fees apply.
LTL rates Washington to Philadelphia
LTL Washington to Philadelphia starts at $328 per pallet on Warp, 2 day transit, all-inclusive. Pickup available this week. Get a live quote at wearewarp.com/ltl/washington-to-philadelphia.
Freight cost Washington to Philadelphia
Freight from Washington to Philadelphia runs $328 per pallet on Warp LTL (1 pallet, 500 lb, all inclusive). 2 day transit. Pickup available this week.
What is the difference between Warp LTL and the other carriers on Warp?
Warp LTL is Warp's own all inclusive cross-dock service. The other carriers on the platform are major LTL providers you can also book on Warp at FAK negotiated rates: national carriers like XPO Logistics, Old Dominion, Estes Express, Saia, FedEx...
What are FAK rates on Warp?
FAK stands for Freight All Kinds. It is a single negotiated rate that applies regardless of the commodity's freight class, typically 15 to 25% lower than class based rates. Direct LTL carriers usually reserve FAK pricing for shippers with $1M+...
How do I book LTL freight on Warp?
Four ways to book LTL Washington to Philadelphia on Warp. (1) Instant freight quote portal at customer.wearewarp.com/public/freight-quote. Enter origin ZIP 20001, destination ZIP 19102, pallet count, weight. Book in 60 seconds with a card on file. (2) Pay as you...
Median $349/pallet across 9 ZIP samples
Rate varies by where the freight is picked up in Washington and where it drops off in Philadelphia. Each route below connects a pickup zone to a drop-off zone. Click any row to open this quote on Warp. Adjust pallet count, weight, and pickup date to match your shipment, then book.
- Downtown
- City center pickup / drop-off
- Warp cross-dock
- Near a Warp LTL cross-dock facility
- Industrial
- Industrial corridor
Warp LTL plus 9+ major LTL carriers on this lane. One signup, one invoice.
Warp gives you our own all inclusive Warp LTL service plus FAK negotiated rates from major national LTL carriers including XPO Logistics, Old Dominion, Estes Express, Saia, FedEx Freight, ABF Freight, R+L Carriers, TForce Freight, and Forward Air, plus regional specialists like Pitt Ohio, Averitt Express, AAA Cooper, Ward Trucking, Dohrn Transfer, Daylight Transport, and more. Pick the carrier that fits. All on Warp. Warp LTL usually has the lowest all in cost because the rate at booking equals the rate invoiced. The carrier options give you flexibility when you prefer a specific provider for service level or transit reasons.
LTL rates: Washington to Philadelphia
1 pallet · 500 lbs · class 70 · all rates as of Apr 21, 2026
+1 more| Carrier — click row to quote | Rate | Transit | vs Warp LTL |
|---|---|---|---|
| Warp LTLWarp Technology's own service · all inclusive | $328All in, surcharge free | 2 days | |
| PITT OHIO | $234 | 1 day | -$94 |
| Forward Air | $313 | 1 day | -$15 |
| A DUIE PYLE INC | $327 | 1 day | -$1 |
| ESTES | $355 | 1 day | +$27 |
| Ward Trucking | $415 | 1 day | +$87 |
| XPO Logistics | $637 | 2 days | +$309 |
Get your exact rate
Washington (20001) → Philadelphia (19102)
Warp LTL's rate above is the full invoice — no fuel surcharge, no liftgate fee, no residential delivery charge. The other carriers listed show base rates only and typically add 6 to 8 surcharges after delivery.
See what they charge ↓$315–$713+ in surcharges Warp doesn't charge
Surcharges the carriers above add after delivery on the Washington to Philadelphia lane. Warp's per-pallet rate is the invoice.
| Fee | Forward Air | Estes Express | XPO Logistics | Range | Warp |
|---|---|---|---|---|---|
| Fuel surcharge | 26% | 24.7% | 27% | 24.7–27.0% | Included |
| Residential delivery | $90 | $100 | $180 | $90–$180 | $0 |
| Liftgate | $75 | $75 | $259 | $75–$259 | $0 |
| Limited access | $100 | $85 | $180 | $85–$180 | $0 |
| Appointment | $25 est. | $25 est. | $68 | $25–$68 | $0 |
| Notification | $25 | $30 | $26 | $25–$30 | $0 |
| Surcharge stack | $315+ | $315+ | $713+ | $315–$713+ | $0 |
Charges shown for a 1-pallet / 500 lb shipment. Sources: Forward Air Expedited LTL Accessorial Charges (March 2026), Estes Accessorial Charges (eff. Nov 2025), Eniture LTL Fee Comparison, XPO CNWY 199-AK.1 Tariff (eff. Feb 16, 2026). Read the full Warp tariff →
Quote Washington to Philadelphia by API
Pay as you go · Sandbox freeReturns live LTL rates for this lane. No contract, no minimum, no sales call. Pull live rates and book the shipment in the same call. Sandbox keys are issued instantly on signup.
curl -X POST https://www.wearewarp.com/api/v1/freight/quote \
-H "Authorization: Bearer wak_test_YOUR_SANDBOX_KEY" \
-H "Content-Type: application/json" \
-d '{
"pickupZip": "20001",
"deliveryZip": "19102",
"pickupDate": "2026-05-26",
"pallets": 1,
"weightPerPallet": 500,
"mode": "LTL"
}'One signup issues both sandbox and production keys. Quote calls are free. Booking charges the card on file at the rate above.
Ask your AI to quote Washington to Philadelphia
MCP · 16 freight toolsDrop the Warp MCP server into Claude Desktop, Claude Code, Cursor, Windsurf, or Continue. Your AI quotes, books, and tracks shipments on this lane from the chat. No portal, no sales call.
1. Add to your MCP config
{
"mcpServers": {
"warp": {
"command": "npx",
"args": [
"-y",
"warp-agent-mcp"
]
}
}
}2. Ask the AI
Quote me Washington to Philadelphia, 1 pallet, 500 lbs, pickup next business day.Quote tools require no login. To also book or track, run npx @warpfreight/cli-agent signup once and credentials save to ~/.warp/config.json.
Why Shippers Choose Warp on Washington to Philadelphia
LTL freight from Washington to Philadelphia
Washington to Philadelphia is served by 9 carriers in the Warp network.
Traditional carrier rates on this lane range from $234 to $637 per pallet with transit times of 1 to 2 days. Warp prices this lane at $328 per pallet with 2-day transit.
Washington DC is one of the most complex commercial delivery environments in the country.
The District has commercial vehicle weight restrictions that limit many deliveries to box trucks and cargo vans, time-of-day rules in the downtown core, and permit requirements for recurring deliveries to certain zones.
Philadelphia is the third-largest metro on the East Coast and a major freight hub on the I-95 corridor between New York and Baltimore.
The South Philadelphia food distribution complex is one of the largest regional produce and food markets on the East Coast, anchoring a significant local LTL demand stream for restaurants, grocers, and food service accounts across the metro.
Carbon footprint of LTL freight from Washington to Philadelphia
A single pallet moving from Washington to Philadelphia over 137 miles emits approximately 9 kg CO2e via Warp cross-dock LTL — your pallet's 1 of 26 share of a 53ft dry van on the linehaul leg.
The same truck fully loaded emits about 221 kg CO2e on this corridor, which is what a dedicated FTL move would cost at the same mileage regardless of how many pallets ride.
Figures use EPA SmartWay emission factors and cover tank-to-wheel fuel combustion at typical payload.
For a recurring program at 100 pallets per year on this lane, the attributed LTL emissions are approximately 1 metric tons CO2e.
These numbers are suitable for Scope 3 Category 4 estimation under the GHG Protocol; see the Warp carbon methodology page for assumptions, sources, and what is excluded (pickup and delivery legs, empty-mile variance, well-to-tank upstream fuel, vehicle embodied emissions).
Frequently asked questions
How much does LTL shipping cost from Washington to Philadelphia?
LTL shipping from Washington to Philadelphia starts at $328 per pallet all-inclusive. Traditional carriers on this lane range from $234 to $637 before surcharges.
Warp includes fuel, liftgate, GPS tracking, and proof of delivery in every rate. Enter your shipment details on the Warp platform and get an instant rate in seconds.
How does Warp price LTL freight from Washington to Philadelphia?
Warp prices LTL freight on a per pallet basis. On the Washington to Philadelphia lane, the rate is $328 per pallet for a standard 500 lb pallet.
The rate is all inclusive with no fuel surcharges, no liftgate fees, and no residential delivery charges. No NMFC codes and no density calculators needed.
What visibility does Warp provide on the Washington to Philadelphia lane?
Warp provides live GPS tracking on every shipment from Washington to Philadelphia, including scan events at Warp cross-dock facilities.
Transit on this lane is 2 days through dedicated routing instead of 3 to 5 terminals. The Warp driver app delivers proof of delivery photos with electronic signatures on every load.
Orbit monitors each shipment in real time, flagging delays before you need to call.
How long does LTL shipping take from Washington to Philadelphia?
Warp LTL transit from Washington to Philadelphia is 2 days. Traditional carriers on this lane range from 1 day to 2 days.
Warp transits faster than traditional terminal carriers because freight moves through Warp cross-dock facilities instead of 3 to 5 terminals.
How does Warp cross docking work on the Washington to Philadelphia corridor?
Freight on the Washington to Philadelphia lane moves through local Warp network carriers on both ends with a dedicated line-haul truck in between.
This eliminates the terminal to terminal routing that adds days to traditional LTL.
Can I get an instant LTL quote from Washington to Philadelphia?
Yes. Warp returns a live all-inclusive rate for Washington to Philadelphia in seconds. The current 1-pallet rate on this lane is $328 with 9 carriers available for comparison.
No callbacks, no waiting for a rep, and no email quotes. The quote is the invoice with no post-shipment surcharges.
Is Warp cheaper than traditional LTL carriers from Washington to Philadelphia?
Warp's all-inclusive rate of $328 per pallet on Washington to Philadelphia includes fuel, liftgate, GPS tracking, and proof of delivery.
Traditional carriers on this lane range from $234 to $637 before surcharges. Warp routes freight through Warp cross-dock facilities instead of terminal-to-terminal hops, compressing transit to 2 days.
What happens if my freight is damaged on the Washington to Philadelphia lane?
Every carrier on the Washington to Philadelphia lane is vetted through Highway before approval. Authority, insurance, safety rating, and operating status are verified automatically.
Carriers carry Carmack Amendment liability up to $100,000 per shipment. Warp maintains a $75,000 FMCSA surety bond.
Additional cargo insurance up to $1,000,000 per shipment is available through Falvey ($0 deductible on LTL under $10K, 0.30% of declared value). Warp files, processes, and resolves claims for you.
What is the carbon footprint of shipping one LTL pallet from Washington to Philadelphia?
A single pallet moving from Washington to Philadelphia via Warp cross-dock LTL emits approximately 9 kg CO2e (tank-to-wheel) — your pallet's 1 of 26 share of a 53ft dry van over the 137-mile linehaul leg.
Dedicated FTL on the same lane emits approximately 221 kg CO2e regardless of how many pallets are on the truck.
Figures use EPA SmartWay emission factors and are suitable for GHG Protocol Scope 3 Category 4 estimation.
See the Warp carbon methodology page for sources, assumptions, and what is excluded (pickup and delivery legs, empty-mile variance, well-to-tank upstream fuel, vehicle embodied emissions).
How much does LTL freight from Washington to Philadelphia cost?
LTL from Washington to Philadelphia is $328 per pallet on Warp, all-inclusive. The rate at booking is the rate invoiced. No fuel surcharge, no liftgate fee, no residential or reweigh charges.
Benchmarked against 9 other LTL carriers on this lane. Get an instant quote at wearewarp.com/ltl/washington-to-philadelphia.
How fast is LTL shipping from Washington to Philadelphia?
2 days transit door to door. Pickup available this week. Carrier-direct LTL on this lane runs faster on some routes and slower on others. See the live comparison table for each carrier's transit.
What is the cheapest LTL carrier from Washington to Philadelphia?
On the Washington to Philadelphia lane, PITT OHIO posts the cheapest base rate at $234 per pallet (snapshot 2026-04-21).
Warp's rate is $328 per pallet, all-inclusive: fuel surcharge, liftgate, and reweigh fees included, so a typical shipment with one or two add-ons lands cheaper on Warp.
Can I book LTL from Washington to Philadelphia online?
Yes. Quote and book at wearewarp.com/ltl/washington-to-philadelphia — enter origin ZIP, destination ZIP, pallet count, and weight, then book in 60 seconds with a card on file.
No sales call, no broker callback, no minimum volume. Pickup available this week.
About the Warp freight network
Ready to ship from Washington to Philadelphia?
Get instant per-pallet rates or talk to Warp about a recurring lane program.
Warp2026Auto-applied at checkoutClick below to open the Warp customer portal — $50 is auto-applied at checkout on your first Warp shipment via Stripe.
One time per customer. Valid on your first booked Warp shipment only. Expires Apr 10, 2027. Subject to Warp’s standard terms of service.
99.2% damage-free across 715,575+ shipments · $100K carrier liability · Live GPS tracking