Section VII: Plastics and articles thereof

HS code chapter 40: Rubber and articles thereof

Chapter 40 of the Harmonized Tariff Schedule of the United States: Rubber and articles thereof. It holds 17 headings, 4001 to 4017, and 198 ten digit US HTS codes.

General duty rates in the chapter run from Free to 14%, and 78 codes (39%) enter free of general duty. The highest percent rates sit under 4015 (14%), 4010 (8%), 4016 (4.3%).

17Headings
198US HTS codes
Free to 14%General duty
39%Codes free

The 17 headings in chapter 40

Each four digit heading with its HTS codes and the span of their general duty rates. 4 headings hold a single code, shown in full below.

HeadingDescriptionHTS codesGeneral duty
4001Natural rubber, balata, gutta-percha, guayule, chicle and similar natural gums, in primary forms or in plates, sheets or strip16Free
4002Synthetic rubber and factice derived from oils, in primary forms or in plates, sheets or strip; mixtures of any product of heading 4001 with any product of this heading, in primary forms or in plates, sheets or strip18Free
4003Reclaimed rubber in primary forms or in plates, sheets or strip1Free
4004Waste, parings and scrap of rubber (other than hard rubber) and powders and granules obtained therefrom1Free
4005Compounded rubber, unvulcanized, in primary forms or in plates, sheets or strip4Free
4006Other forms (for example, rods, tubes and profile shapes) and articles (for example, discs and rings), of unvulcanized rubber3Free to 2.9%
4007Vulcanized rubber thread and cord1Free
4008Plates, sheets, strip, rods and profile shapes, of vulcanized rubber other than hard rubber9Free to 3.3%
4009Tubes, pipes and hoses, of vulcanized rubber other than hard rubber, with or without their fittings (for example, joints, elbows, flanges)122.5%
4010Conveyor or transmission belts or belting, of vulcanized rubber351.9% to 8%
4011New pneumatic tires, of rubber34Free to 4%
4012Retreaded or used pneumatic tires of rubber; solid or cushion tires, tire treads and tire flaps, of rubber24Free to 4.2%
4013Inner tubes, of rubber6Free to 3.7%
4014Hygienic or pharmaceutical articles (including nursing nipples), of vulcanized rubber other than hard rubber, with or without fittings of hard rubber3Free to 4.2%
4015Articles of apparel and clothing accessories (including gloves, mittens and mitts), for all purposes, of vulcanized rubber other than hard rubber8Free to 14%
4016Other articles of vulcanized rubber other than hard rubber22Free to 4.3%
4017Hard rubber (for example, ebonite) in all forms, including waste and scrap; articles of hard rubber12.7%

4 headings with a single HTS code

These headings have one ten digit code each, so the code and its rates are here in full.

4003: Reclaimed rubber in primary forms or in plates, sheets or strip

“Reclaimed rubber in primary forms or in plates, sheets or strip.”

HTS code
4003.00.00.00
General
Free
Column 2
Free
Units
kg
Special
None listed
Price it

4004: Waste, parings and scrap of rubber and powders and granules

“Waste, parings and scrap of rubber (other than hard rubber) and powders and granules obtained therefrom.”

HTS code
4004.00.00.00
General
Free
Column 2
Free
Units
kg
Special
None listed
Price it

4007: Vulcanized rubber thread and cord

“Vulcanized rubber thread and cord.”

HTS code
4007.00.00.00
General
Free
Column 2
35%
Units
kg
Special
None listed
Price it

4017: Hard rubber in all forms, including waste and scrap

“Hard rubber (for example, ebonite) in all forms, including waste and scrap; articles of hard rubber.”

HTS code
4017.00.00.00
General
2.7%
Column 2
80%
Units
kg
Special
Free (A,AU,B,BH,C,CL,CO,D,E,IL,JO,KR,MA,OM,P,PA,PE,S,SG)
Price it

The most common general duty rates in chapter 40

General duty rateHTS codes
Free78
4%22
2.5%21
3.4%20
3.3%9
1.9%5
2.7%5
2.8%5

Chapter 40 notes

The legal notes at the head of the chapter decide what it covers and what it leaves to other chapters, so read them before you settle on a heading. They are the schedule’s own text, 827 words.

Read the chapter 40 notes

Notes

1. Except where the context otherwise requires, throughout the tariff schedule the expression "rubber" means the following products, whether or not vulcanized or hard: natural rubber, balata, gutta-percha, guayule, chicle and similar natural gums, synthetic rubber, factice derived from oils and such substances reclaimed.

2. This chapter does not cover:

(a) Goods of section XI (textiles and textile articles);

(b) Footwear or parts thereof of chapter 64;

(c) Headgear or parts thereof (including bathing caps) of chapter 65;

(d) Mechanical or electrical appliances or parts thereof of section XVI (including electrical goods of all kinds), of hard rubber;

(e) Articles of chapter 90, 92, 94 or 96; or

(f) Articles of chapter 95 (other than sports gloves, mittens and mitts and articles of headings 4011 to 4013).

3. In headings 4001 to 4003 and 4005, the expression "primary forms" applies only to the following forms :

(a) Liquids and pastes (including latex, whether or not prevulcanized, and other dispersions and solutions);

(b) Blocks of irregular shape, lumps, bales, powders, granules, crumbs and similar bulk forms.

4. In note 1 to this chapter and in heading 4002, the expression "synthetic rubber" applies to:

(a) Unsaturated synthetic substances which can be irreversibly transformed by vulcanization with sulfur into non-thermoplastic substances which, at a temperature between 18°C and 29°C, will not break on being extended to three times their original length and will return, after being extended to twice their original length, within a period of 5 minutes, to a length not greater than 1-1/2 times their original length. For the purposes of this test, substances necessary for the cross-linking, such as vulcanizing activators or accelerators, may be added; the presence of substances as provided for by note 5(b)(ii) and (iii) is also permitted. However, the presence of any substances not necessary for the cross-linking, such as extenders, plasticizers and fillers, is not permitted;

(b) Thioplasts (TM); and

(c) Natural rubber modified by grafting or mixing with plastics, depolymerized natural rubber, mixtures of unsaturated synthetic substances with saturated synthetic high polymers provided that all the above-mentioned products comply with the requirements concerning vulcanization, elongation and recovery in (a) above.

5.

(a) Headings 4001 and 4002 do not apply to any rubber or mixture of rubbers which has been compounded, before or after coagulation, with:

(i) Vulcanizing agents, accelerators, retarders or activators (other than those added for the preparation of prevulcanized rubber latex);

(ii) Pigments or other coloring matter other than those added solely for the purpose of identification;

(iii) Plasticizers or extenders (except mineral oil in the case of oil-extended rubber), fillers, reinforcing agents, organic solvents or any other substances, except those permitted under (b);

(b) The presence of the following substances in any rubber or mixture of rubbers shall not affect its classification in heading 4001 or 4002, as the case may be, provided that such rubber or mixture of rubbers retains its essential character as a raw material:

(i) Emulsifiers or antitack agents;

(ii) Small amounts of breakdown products of emulsifiers;

(iii) Very small amounts of the following: heat-sensitive agents (generally for obtaining thermosensitive rubber latexes), cationic surface-active agents (generally for obtaining electro-positive rubber latexes), antioxidants, coagulants, crumbling agents, freeze-resisting agents, peptizers, preservatives, stabilizers, viscosity-control agents or similar special-purpose additives.

6. For the purposes of heading 4004 the expression "waste, parings and scrap" means rubber waste, parings and scrap from the manufacture or working of rubber and rubber goods definitely not usable as such because of cutting-up, wear or other reasons.

7. Thread wholly of vulcanized rubber, of which any cross-sectional dimension exceeds 5 mm, is to be classified as strip, rods or profile shapes, of heading 4008.

8. Heading 4010 includes conveyor or transmission belts or belting of textile fabric impregnated, coated, covered or laminated with rubber or made from textile yarn or cord impregnated, coated, covered or sheathed with rubber.

9. In headings 4001, 4002, 4003, 4005 and 4008, the expressions "plates", "sheets" and "strip" apply only to plates, sheets and strip, and to blocks of regular geometric shape, uncut or simply cut to rectangular (including square) shape, whether or not having the character of articles and whether or not printed or otherwise surface-worked, but not otherwise cut to shape or further worked.

In heading 4008 the expressions "rods" and "profile shapes" apply only to such products, whether or not cut to length or surface-worked but not otherwise worked.

Additional U.S. Notes

1. For the purposes of subheading 4008.21, the rate of duty "Free (B)" appearing in the "Special" subcolumn applies only to articles measuring not more than 38.1 cm in width and not more than 45.7 cm in length.

2. For the purposes of subheading 4008.29, the rate of duty "Free (C)" appearing in the "Special" subcolumn applies only to profile shapes that are cut to size.

3. For the purposes of heading 4017, the rate of duty "Free (C)" appearing in the "Special" subcolumn applies only to tubes and pipes having attached fittings.

Section VII: the 2 chapters

  • Chapter 39: Plastics and articles thereof
  • Chapter 40: Rubber and articles thereof (this chapter)

Before you file

The importer is responsible for the classification it declares, and a licensed customs broker confirms it. Warp is not a customs broker, and these pages are not customs advice. The rates here are the schedule’s own columns: additional duties that depend on the country of origin, such as Section 301, sit in chapter 99 and are not in them, and neither are the entry fees. The landed cost calculator adds the ones it covers, and the HTS code lookup searches every line by product.

Source: Harmonized Tariff Schedule of the United States, US International Trade Commission, Revision 23 (2026). Codes, descriptions, duty rates and units read November 14, 2026. Chapter notes read November 16, 2026.